BE SURE
SAW IS UNPLUGGED BEFORE PERFORMING MAINTENANCE
ON YOUR
BEAM CUTTER
X
SAW Please follow saw manufacturer's guidelines for proper maintenance.
BEAM
CUTTER CHAIN BAR
Keep the chain bar sprocket tip well lubricated with frequent applications
of lubricant to the chain bar tip.
When lubricating the sprocket tip, wear heavy gloves and make sure the
power cord is unplugged.
1. Clean the sprocket tip to remove
any debris.
2. Insert the tip of the lubricating
gun into the lubrication hole and inject grease until it appears
on the outside edge of the sprocket tip.
3. Rotate the chain by hand and repeat
the procedure until the entire sprocket tip is lubricated.
X ALWAYS USE
HEAVY DUTY GLOVES
WHEN HANDLING
THE CHAIN TO
PREVENT
ACCIDENTAL
INJURY TO
HANDS OR FINGERS.
X
4. Spraying
the bar and chain with a silicone lubricant is very effective
for keeping the chain sharp and running smoothly. Spray every
10 or 15 cuts.
5. The Prazi Beam Cutter runs much slower than a chain saw and does
not require as much lubricant. Clean the chain bar rails when they appear
dirty and each time the chain is removed. The tip of a screwdriver works
well for this job.
CHAIN
Maintain proper chain tension. Proper tension is important and should
be checked before each use
.
Always
keep chain clean and sharp to prevent kickback and to ensure
optimal performance and safety.
New chains will require adjusting after as few as 5 cuts. This is normal,
as new chains often will stretch.
