|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
PRAZI
BEAM CUTTER™
Model PR-7000
How To Change The Chain
|
|
 |
|
|
|
|
BE SURE
SAW IS UNPLUGGED BEFORE PERFORMING MAINTENANCE
ON YOUR
BEAM CUTTER
X |
|
|
|
|
|
FOLLOW
THESE STEPS
1. Remove Beam Cutter from saw.
2. Remove chain bar by first removing
chain bar retention bolt and washer.
3. Separate bearing housing from back
plate by unscrewing hex screws with 5/32" hex key.
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
X
ALWAYS USE
HEAVY DUTY GLOVES
WHEN HANDLING
THE CHAIN TO
PREVENT
ACCIDENTAL
INJURY TO
HANDS OR FINGERS.
X |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4. Make
sure chain cutters face in the direction of rotation. |
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5. Place
chain behind clutch drum and onto sprocket teeth. |
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
6. Reattach
bearing housing to back plate by replacing hex screws, then
reattach chain bar with bolt and washer.
7. Guide chain along the top of the
chain bar and around the sprocket tip, setting drive links in the
chain bar rail. It may be necessary to adjust the sprockets on the
chain bar nose.
8. Pull chain bar forward to take up
slack in the chain and tighten bolt with wrench to firmly secure
it. Make sure the chain fits in chain bar rail along bottom of bar.
Move chain back and forth to make sure it is in mesh with the sprocket
and that chain drive links are lined up with the chain bar rails.
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
