Be
sure to inspect the following before operating the Beam Cutter:
CORD:
OIL:
CHAIN:
Inspect
cord and extension cord for damage.
Oil the chain before use. Inspect for proper tightness and sharpness.
AVOID
KICKBACK! Kickback is a dangerous
occurrence where the saw has a tendency to kick back toward the user
when it encounters resistance. Kickback results in a backward and/or
upward motion of the saw and occurs most frequently when attempting
to cut too close to the tip of the guide bar.
To Avoid Kickback:
WEAR
SAFETY
GOGGLES WITH
SIDE SHIELDS FOR
EYE PROTECTION
WHEN OPERATING
THE BEAM CUTTER
OR ANY OTHER
POWER TOOL
ALWAYS work
with a sharp, tight chain and support your work properly.
If the chain binds while making a cut, or when making an incomplete cut,
release the trigger and hold the saw still until the chain comes to a
stop. DO
NOT attempt to remove the saw from the work while the chain is
moving.
PULL the trigger and allow the chain
to reach full speed before resuming or starting a cut.
ALWAYS use two hands and maintain
a firm grip.
DO NOT attempt to cut material above
shoulder height.
DO NOT attempt to cut in awkward
positions.
Operating
Hints:
• Always secure material to be cut.
• For rip cuts, use a fence to make smooth, straight cuts.
• Do not allow scraps to build up beneath blade.
• Keep chain sharp and well lubricated.
• Keep work area clean and clutter free.
• Grasp saw with a firm grip, using both hands.
